Portrait Phone Adapter for DualShock 4 Phone Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modular portrait phone adapter for DualShock 4 mounts, prints in 4 parts.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 6
- Makes
- 0
- Views
- 117
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This adapter allows a standard DualShock 4 phone mount to hold your phone in portrait orientation instead of the usual landscape mode.
It was specifically designed for the Dobe PS4 Mount Clamp, as many phone mounts available online appear to use the same design and dimensions. Compatibility with other similar mounts is possible, but cannot be guaranteed. If your mount differs, feel free to leave a comment or send me a direct message with its dimensions. I'll do my best to adapt the design or create a compatible version.
I originally designed this adapter for playing Nintendo DS games on my phone, where portrait orientation provides a much more natural and enjoyable experience.
Design Goals
This project was designed around two main objectives:
Be easy to manufacture using either 3D printing or 6 mm sheet material (such as acrylic, plywood, or MDF) with a laser cutter or CNC machine.
Rather than creating a large one-piece adapter with complex geometry, this design consists of four flat pieces that are assembled only when needed.
The result is a simple, lightweight, and portable adapter.
Phone Compatibility
The current version is designed for phones up to:
78 mm width
10 mm thickness
These dimensions were chosen specifically to fit my Motorola G86 5G with its protective case.
If your phone has different dimensions, feel free to leave a comment with its width, thickness, and any additional clearance you may need. I'll upload additional size variations to support more phones without making the design unnecessarily bulky or complicated.
Required Parts:
2× 'center_pieces'
1× 'top_arms'
1× 'bottom_arms'
Installation
This adapter is designed for the common commercial DualShock 4 phone mount, which consists of:
the transparent support piece ("arms"), and
the phone clamp.
For the best fit, adjust the phone clamp, so it is as parallel as possible to the transparent support arms, as shown in the photo.

After testing several positions, I found this angle to be the most comfortable for everyday use. However, if there is enough interest, I can upload an alternative version that raises the phone slightly, providing a steeper viewing angle toward the controller.
Once the phone clamp has been adjusted and the adapter is fully assembled, position the DualShock 4 clamp as high as possible. Insert the lower hooks first, then slide the assembly downward until it locks into place.

Why this Design?
I intentionally avoided designs that rely on rubber bands, flexible clamps, or adjustable mechanisms. While those can fit more devices, they also make the adapter:
bulkier,
more difficult to manufacture,
less travel-friendly, and
more prone to wear.
Instead, this design keeps everything rigid and simple. Different phone sizes can be supported through dedicated versions, maintaining the same clean, compact design philosophy.