Large soap dish
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€3.70 – €4.52 net (excluding VAT)
For file: soap_dish_0.2mm_PLA_MINI_4h17m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €4.11 excluding VAT (range midpoint).
- Weight reported by the author
- 48 g
- Print time reported by the author
- 4.28 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Soap dish to hold larger bars.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 13
- Makes
- 0
- Views
- 217
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Share Alike
Simple dish without bottom that can hold larger bars of soap. The shape helps with drying to avoid making a goopy mess. Side without a wall is supposed to be oriented forward, towards the sink, to allow excess water to escape.
Dimensions: 118mm x 84mm x 20mm
Filament used on the photo: Filamentum PLA Extrafill "Traffic White"
Printing instructions
PLA with 0.2mm QUALITY preset in PrusaSlicer, seam position = rear.
Additional notes:
- PETG (or any warp-prone filament) will probably warp significantly with this geometry.
- If you use a different slicer: the preset is 2 perimeters and 15% gyroid infill.
- Extra-sturdy version: 7 perimeters. Will get you almost perimeter-only print, but needs 30g more filament and 2h more print time. Personally, I find this excessive - normal version is very sturdy as is.
- No supports needed - bridges on top came out fine for me.