Mechanical RSA Token Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Overengineered mechanical stand for holding an RSA SecurID token at an angle. Also, doubles as a pretty good fidget toy!
- Rating
- 5 / 5
- Likes
- 4
- Downloads
- 15
- Makes
- 1
- Views
- 165
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
Frustrated by glare on my RSA securid token's display, I made a stand for it where I could adjust the angle to eliminate the glare. It also makes a great fidget toy.
I designed the model to be printed in multiple materials. PETG for the geared shaft, and PLA for everything else. In theory, the clearances in the model should allow it all to be printed in the same material type on a well tuned printer. but I have not tried.
The attached 3MF file has all the support painting, part modifiers, etc tuned in as I printed them, but to enumerate the material ones:
Generic Settings:
Nozzle Size: 0.4mm
Layer Height: 0.15mm
Perimeters: 3
Scarf Joint Placement: Everywhere
Scarf Joint on Inner Perimeters: yes
Infill Density: 30%
Infill Type: Cubic
Brim: Outer brim only.
Brim Width: 5mm
Shaft Settings:
Perimeters: 6
Infill Density: 50%
The model is mostly designed to be printed without supports, though for a nicer surface finish on the inside of the indent where the token goes, I normally support the upper lip.
