XShot MPP Magnet Jam Door
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A screwless Jam Door replacement for the XShot Motorized Piston Pump jam door.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 22
- Makes
- 0
- Views
- 122
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Inspired by GhostManta's Jam Door models, I wanted something that would replace the need to get a screw driver any time I needed to clear a jam.
This is a drop-in replacement for the stock Jam Door, just take out the retaining screw and the stock door pops out. To install this mod put an M3-8mm socket screw in the blaster, this is what the magnet will stick to. Glue a 5mm diameter 2 mm thick magnet into the boss on the back side of this jam door. Once the glue is dry then this door just pops into the blaster shell. Depending on your print settings you may need to sand the hinge nubs on this print to get a good fit.
This jam door engages with the existing clips in the MPP's shell, and the magnet holds onto the M3 screw head for a pretty secure closure, but is still easy to open with the finger pull at the top without the need for additional tools
BOM:
1x M3-8mm socket head screw like one from this kit
I ended up printing vertically, shown in the photos, with supports on and the print ended up pretty clean. I used 4 walls and 20% infill, but you can probably get away with less.