The Drinkall Ligation Station - a knot trainer for medical / veterinary students
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple print, no supports. Creates a ligation / knot trainer to simulate various scenarios, and levels of challenge.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 11
- Makes
- 0
- Views
- 638
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Medical Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Created by Dr. Emma Drinkall, Assistant Professor, University of Nottingham School of Veterinary Medicine and Science - email [email protected]
A simple print, no supports needed. If given the option to make overhangs printable on the pot, select this for a slightly cleaner print.
This kit creates an affordable, reusable ligation / knot trainer to simualte various scenarios, and levels of challenge for students.
Tie quick release knots on the top rings, or around the uprights, or tie surgical knots around the hair tie, to oppose the bands, or deep into the pot to the eye.
Simply lift the pot to cut / untie ligatures from the eye bolt.
You can run a tubing line eg giving set to tube through the top holes of the uprights to create a bleeding line to test ligatures.
Easily fixed to surfaces with suction cups, small F clamps, or bolts. This can move to a range of teaching environments.
Assembly is simple, as shown in the photos.
Released under Creative Commons - attribution, non commercial, shared alike. Attribution details above.
Additional resources needed:
4x suction cups (mine are xmas light holders, 35mm diameter outer, 12mm diameter stalk, adding a fialment section the gap improves the friction fit to the base but is not needed)
1-2 x split ring
1 x elastic hair tie
2 x F clamps
Paracord, suture material
1 x Needle holders - please make sure to provide left handed kit for class use cases.
1 xEye bolt - M5 / 5mm