1 / 1
Desk Fan with 4x Noctua NF-A14 — image 1

Desk Fan with 4x Noctua NF-A14

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Desk fan, build using 4 Noctua NF-A14 fans

Rating
0 / 5
Likes
15
Downloads
30
Makes
0
Views
337
Reviews
0

Updated at source:

Model information

Category
Office
License
Creative Commons — Attribution

Desk fan, build using 4 Noctua NF-A14 fans.
Designed for "NF-A14 PWM chromax.black.swap" fans, since their short built-in cable makes wiring easy by using a few wires soldered to pin headers as extensions. Wiring the fans up neatly with the brown NF-A14s might be a bit more involved.
All M4x12 bolts thread into the printed part, cutting their own threads. 

Required hardware:
4x NF-A14 PWM chromax.black.swap
32x M4x12 SHCS/BHCS
2x M4x25 HHCS
2x M4 Knurled Nut

Recommended wiring:
Using four "NF-A14 PWM chromax.black.swap", 12 PTFE wires, 3 for each fan, soldered to a 2.54mm pin header. If PWM control is not needed or the tachometer output is wanted, use 2 or 4 wires per fan respectively.
All wires enter from the bottom through the printed part, and meet at the center of the four fans. There, they are plugged into their corresponding fan. Rotating the fans as seen in the picture makes this easier.
The "Cable Support" part is attached using the two bottom-center bolts of the two fans at the bottom and help redirect the cables to the back (instead of them protruding to the bottom, scraping the ground).

Tags