Desk Fan with 4x Noctua NF-A14
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Desk fan, build using 4 Noctua NF-A14 fans
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 336
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
Desk fan, build using 4 Noctua NF-A14 fans.
Designed for "NF-A14 PWM chromax.black.swap" fans, since their short built-in cable makes wiring easy by using a few wires soldered to pin headers as extensions. Wiring the fans up neatly with the brown NF-A14s might be a bit more involved.
All M4x12 bolts thread into the printed part, cutting their own threads.
Required hardware:
4x NF-A14 PWM chromax.black.swap
32x M4x12 SHCS/BHCS
2x M4x25 HHCS
2x M4 Knurled Nut
Recommended wiring:
Using four "NF-A14 PWM chromax.black.swap", 12 PTFE wires, 3 for each fan, soldered to a 2.54mm pin header. If PWM control is not needed or the tachometer output is wanted, use 2 or 4 wires per fan respectively.
All wires enter from the bottom through the printed part, and meet at the center of the four fans. There, they are plugged into their corresponding fan. Rotating the fans as seen in the picture makes this easier.
The "Cable Support" part is attached using the two bottom-center bolts of the two fans at the bottom and help redirect the cables to the back (instead of them protruding to the bottom, scraping the ground).