Shorty Mag Block for Ruger 9mm PCC using mags for Glocks
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a remix of a previous mag block with 7mm removed and a slot added to attach a flag
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 10
- Makes
- 0
- Views
- 56
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
Print this with the base flat on the build plate. No supports needed. The body of the mag block will print at an angle which is not a problem. Use whatever material you think will stand up to the temperatures your PCC will see in use.
The block on the right side in the photos is the original version. The last two photos show a PC Carbine with Holosun dot being put into an S3 rifle scabbard for traditional stock.
This mag block satisfies the requirements for Steel Challenge matches I've been to, the bolt will close against it. Check the rules of whatever organization you're competing in to make sure they do not require the chamber to be filled.