Big agitator rod / stirrer to fit the Paterson Super System 4 rotary development tanks
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.98 – €1.20 net (excluding VAT)
For file: Agitator Rod v1.1_0.4n_0.2mm_PLA_COREONE_1h1m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.09 excluding VAT (range midpoint).
- Weight reported by the author
- 15 g
- Print time reported by the author
- 1.02 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Agitator rod, longer with more leverage to make developing film in rotary development tanks more pleasurable.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 22
- Makes
- 0
- Views
- 114
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Open Community License v1.1 + General Attribution v1
Hi
This is an alternative agitator rod for the Paterson Super System 4 rotary development tanks.

I have two issues with the original agitator rods:
They are so short you easily get photochemistry on your fingers if you're not careful when filling the tanks or the tanks are over filled.
I typically include abrupt changes in direction to introduce a little turbulance when agitating. The rod is too narrow with minimal leverage, if you do multiple rounds of development or use larger tanks your fingers can get tired / start hurting and its difficult to use enough force to shake the reels enough to dislodge air bubbles.
With the new rod, your fingers are further from the chemicals, not inside the tank, and you have more leverage so you need less effort to agitate and can easily whip the reels back and forth to remove bubbles.
Agitating larger five and eight reel tanks requires much less effort.
Features
![]() | Wider knob to provide more leverage/grip |
![]() | Chamfered slot opening to self align a bit easier |
![]() | Longer shaft to avoid getting your fingers wet |
Open to suggestions for improvements.
Printing Instructions
Orientation
This was intended to be printed vertically with the widest section at the bottom with no supports.

Print Settings Used
Material: Prusament PLA
0.4mm Nozzle with 0.2mm Structural Preset
Variable layer height
Perimeters: 4
Infill (not important): Gyroid 15%
I sadly did not have any red filament to make the top red when printing these.
Versions
I created a second version with rounded over edges, the first version is more grippy so I kept it.
Version 1 (Green photos) | Version 1.1 (Orange photos) | Change |
|---|---|---|
![]() | ![]() | Smoother corners, less grippy but more comfortable |
![]() | ![]() | Deeper channels and more sloped face to engage more easily |
Support the original manufacturer by purchasing from them: https://patersonphotographic.com/shop/
(I have no relationship with them and do not benefit from you using the link)






