Retrofit Nub Mounts for design8studio's Minimal Enclosure v3.0 & AD5M LED Light Bar Strip Kit
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The same LED mount cut out from the front risers of the design8studio v3 minimal enclosure. Use to relocate the LED bar
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 105
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to relocate the FlashForge LED strip kit from the front, to the right side of the case in order to prevent the PTFE tube rubbing against the sharp-cornered LEDs. I recommend a good gel CA glue to mount these to the right risers.
If you haven't printed your risers yet, you can add these to the 2 right STP riser files, so they print with them pre-installed. The original front riser STP file shows the nub mount center to the edge as 100.617mm and the distance between the installation holes on the FlashForge LED strip bar is about 201-202mm, on center.
**With the light installed on the right side, a narrow shadow will be cast on the right side of the build plate as it gets lower, due to the wide ledge, but its not an issue.
The LED bar's power connector should be on the left (towards the rear of the case) to install properly, I provided a picture of how I routed the power cable using tape. This also solved the problem of the extruder assembly pinching the LED power cable in the front-right corner.