1 / 4
Air Vent Deflector, 330mm/13 inch
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Keeps vent from blowing hot/cold air on you.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 10
- Makes
- 0
- Views
- 65
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
Deflector is 330mm (13 in.) wide. For most printers, cut in half in your slicer, tape and glue using the provided brace on the inside at the seam. Or if your printer can handle it, print in one piece. Model takes up to (9) magnets, 20mm x 5 x 2, or use fewer if you like. Slicer file has "mouse ear" pads to prevent warping, just peel these off after printing. Works fine in PLA.