Wall Mount Holder for 3/4" & 19mm Bench Clamps and Fixture Blocks (e.g. Fireball Tool clamps)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A pair of magnet-assisted holders for bench clamps, fixture blocks, bench dogs, etc. for tables with 3/4" or 19mm holes.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 6
- Makes
- 0
- Views
- 52
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed these holders primarily to keep the bench clamps for my welding fixture table from being piled in a drawer, and up out of the way but still easy to access. I have a ceiling beam running across part of my workshop which was otherwise wasted vertical space, so I have been using it to hang my welding clamps from. But these could also be screwed to a wall, or you could mount them to a horizontal bracket to locate the bar clamps for your fixture table vertically.
These should fit either 19mm or 3/4" (basically the same size) clamps and fixtures. I believe they will fit the Fireball Tool "quick clamps" but I cannot verify this at this time, since I modified standard welding bar clamps to make my own bench clamps. As long as the 3/4" pin on the bottom of the clamp is .800" long or longer, they should make contact with the magnet for extra retention. The magnets are a standard 10mm x 3mm round neodymium magnet (Amazon, etc). The recess for the magnet is designed to be a press fit, although I would recommend adding a drop of glue prior to seating the magnets. The screw holes will accommodate either a #10 or an M5 screw for mounting.
The larger 4 recess holder is what I am using for all of my bar clamps for the fixture table. I also made a single recess version which I am using to hold my Fireball push blocks, which are a little awkward to store any other way due to their odd geometry. Since I designed the single recess unit specifically for this use the filename reflects that, but of course you could also use it to hold many other items in the Fireball system.
Be careful where and how you mount these. I have mine up high enough that at 6' I can easily walk under them without ducking, but still within easy reach above where my fixture table sits. Avoid mounting them where it would be easy to bump the ends of the clamps, which could cause injury or break the holder. Don't skimp on the print settings... Use plenty of perimeters and no less than 20% infill.
I printed these out of Polymaker ABS on my Voron 2.4 and Voron Trident, using 0.6mm nozzles, 4 perimeters, and 0.3mm layer height.