1 / 16
Lazy-Tongs Snapping Dragon — extending scissor grabber — image 1
1 / 16

Lazy-Tongs Snapping Dragon — extending scissor grabber

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A lazy-tongs scissor reacher themed as a dragon: squeeze the tail and the neck telescopes out while the head snaps shut…

Rating
1 / 5
Likes
2
Downloads
11
Makes
1
Views
97
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

An extending Nuremberg-scissor (lazy-tongs) grabber-reacher themed as a snapping dragon. It has ONE moving mechanism and a single degree of freedom: squeeze the tail handle and the shared scissor angle shrinks, so the neck telescopes forward (~135 mm collapsed → ~213 mm extended) and the head snaps shut at the same time. Reach and bite are the same motion — spread the tails to collapse and re-open the mouth.

Snap-pin assembled build (no glue, no supports): two rails of scissor links offset by one layer, pinned at every crossing with printed snap-rivets. Fully parametric in OpenSCAD (reach, jaw close angle, bar/pin sizes).

23 printed parts — 10 links + 13 snap-pins, across 7 STLs.

Print: everything flat, no supports. Pins print standing (flange down, barb up); PETG recommended for the pins, PLA fine for the rest. Print one pin + one link as a fit coupon first.

Assembly

Step 1 — belly rail. Lay handle → 3 links → upper jaw in scissor order.

step 1

Step 2 — spine rail. Lay the spiked spine rail over it, offset one layer.

step 2

Step 3 — crossing pins (x5). Pin each scissor "X" through the centre holes.

step 3

Step 4 — side-joint pins (x8). Pin the cell boundaries at the end holes.

step 4

Squeeze to reach + bite; spread to collapse + gape.

Tags