ExoBass - Head - Exploder

Part of the ExoBass project — full catalog, build planner, and assembly guides at https://exobass.com

Plan Your Build & Get Hardware

ExoBass can be confusing! Head over to our build planner to plan your entire build - it'll walk you through every available part and handle compatibility along the way, and it covers all ExoBass parts. It's also the best way to get hardware, since it lets you buy everything for a full build in one go, not just this part.

You can find this specific part, ExoBass - Head - Exploder, on our site.

Note: These instructions were documented using one specific head design. The head you are building might not look exactly the same, but the assembly steps and general approach should be similar.

Step 1: Heat Set Inserts

Using a soldering iron, put in the heat set inserts

Step 2: Grub Screws

Step 3: Install Tuners

Step 4: Attach to 2020 with M6x20

Hardware

DIY Kit

You can order a DIY kit for your entire build from our build planner, the estimate for this part's kit is $12.57 plus shipping.

Self Source

If you want to order the parts yourself, here's a list. Estimated cost: $39.44.

• 1x Screw - Socket Head - M6x25
• 2x Heat Set Insert - M3 - 5mm OD - 4mm L
• 2x Screw - Grub - M3x16
• 4x Machine Heads - Bass - 6R