Voron 350mm +110mm Tall Top Hat
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Full 350mm Z Travel V2.4** Adds 110mm additional Z clearance. Load bearing-ish. Works great. Remixes welcome.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 17
- Makes
- 0
- Views
- 840
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution
Extra Tall Modified Top Hat - 350mm Voron 2.4 and Trident
This mod increases Z clearance height by 110mm and improves cable management (Can Bus / Umbilical style) by raising the top. Requires re-routed cabling and filament path (not shown)
Standard Build: Gave me 348mm total Z travel on a stock OG V2.4 build. (tested with LDO rails, Rapido UHF A4t, and stock gantry/table).
Modified Build: Up to 355mm MAX Z if you shift the Z rails up a few mm. (results may vary, works on mine)
Print Specs
ABS (40% Fill Voron Specs)
TPU seam fill (100% Fill) — You may need to tune the thickness or substitute with foam/foam tape.
Hardware
Square nuts M3 - 8 pcs
M3 T nuts - 16
M3 x 8 or 10mm SHCS to mount to frame. - 16
M3 x 4mm SHCS for color accent plugs. (or glue. Or M5 with washers, too long screw pokes thru)
Design
Z Clear for Toolhead: Designed to clear Nighthawk 36 or Can Bus tool head cabling. Cpap Etc
Appearance: Classic Aesthetic that fits the original
Flat Rear Panel: Flat Blank Plate to mod for fans, cable/filament routing, etc.
Lighting: Includes LED strip clearance and specific "light pocket" areas (with zip-tie grooves).
Customization: Uses a standard hex pattern for adding buttons or color chips.
Assembly: Uses stock top and printed corner clips.
I intended to make a smooth and dialed model here. That didn't happen. It works, but it could be way more dialed. If folks like it, I'm sure they can refine it way better.
Super shallow M3 screws to hold color insert plates or it'll poke thru. Also that.