Configurable Spring Internals for Finisher 3.X Nerf blaster
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Allows for different sized springs (from the hardware store) to fit snuggly in the Finisher 3.X blaster
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 4
- Makes
- 0
- Views
- 56
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I was able to source a spring from my local Ace Hardware store however it was wider than the original design's intended spring.
This remix include a wider spring rod base so wider springs will catch and not partially go over the base.
The spring stop was adjusted so the round spring fits snuggly & centered in the round depression. A variety of sizes are provided for 15mm to 20mm diameter springs. It also has a directional notch indicating the side of the non-square stop that should point towards the front of the blaster when inserted.
My spring assembled fully extended was not strong enough, I had to assemble it partially compressed to achieve decent force, which meant putting the stop on under pressure.
Same as the original model, print them fully solid, so 5-8 walls and 100% infill