Tapo T310 Wall holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wall holder with optional distance piece fore the Tapo T310 temperature and humidity sensor
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 39
- Makes
- 0
- Views
- 107
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to mount my Tapo T310 sensors to the wall in a nice way. I mounted one of them to one of the posts of my patio roof and I wanted the heat of the post not no influence the measuring too much. For that reason I also added a distance piece to thermally decouple the sensor.
I printed it in PETG but for indoor use PLA might be fine. I used tree supports which I also did allow at the object with a relatively high distance between support and object. Be carefull when removing the support. With pliers you can just pull it out.
Edit: I added another two versions. One without the hole and one version (main part and hook) which fit an IKEA Skadis board.