AS5600 breakout board mount for NEMA17
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A press fit sleeve for nema17 stepper motors to attach an as5600 (magnetic encoder) breakout board.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 12
- Makes
- 0
- Views
- 86
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Public Domain
-The sleeve is just friction fit, you may adjust fit by changing your filament shrinkage parameter. Fit is solid with PLA, for frequent disassembly I would use TPU, and for a permanent solution PETG.
-The mount does not include through-holes for header pins, I would advice you to solder wires directly to the board. You may create holes with a negative volume modifier.
-My stepper motor's shaft is not flush to the end surface (there is a counterbore), thus I had to create an "applicator" to help position the magnet as concentric as possible in the tight space.
-Your stepper's geometry might vary, take this into account as the magnet needs to be positioned 0.5-3mm above the IC. In my model, you can easily adjust the spacing by increasing the thickness of "Spacer" along Z.
-Most dimensions are optimized for 0.6mm nozzle, as it prints faster. I expect a 0.4mm nozzle to provide good results either way.