AS5600 breakout board mount for NEMA17
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A press fit sleeve for nema17 stepper motors to attach an as5600 (magnetic encoder) breakout board.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 86
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
-The sleeve is just friction fit, you may adjust fit by changing your filament shrinkage parameter. Fit is solid with PLA, for frequent disassembly I would use TPU, and for a permanent solution PETG.
-The mount does not include through-holes for header pins, I would advice you to solder wires directly to the board. You may create holes with a negative volume modifier.
-My stepper motor's shaft is not flush to the end surface (there is a counterbore), thus I had to create an "applicator" to help position the magnet as concentric as possible in the tight space.
-Your stepper's geometry might vary, take this into account as the magnet needs to be positioned 0.5-3mm above the IC. In my model, you can easily adjust the spacing by increasing the thickness of "Spacer" along Z.
-Most dimensions are optimized for 0.6mm nozzle, as it prints faster. I expect a 0.4mm nozzle to provide good results either way.