Ender 3 v3 SE single 5015 fan split duct right side mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Right 5015 blower fan duct for the Ender 3 V3 SE. Closer to the nozzle and bed with an extra exhaust duct
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 16
- Makes
- 0
- Views
- 131
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Noticed that the origional one from felipejfc did have great airflow but felt like the exhaust could be brought closer to the printbed and nozzle.
So for my first-ever Fusion 360 design, I came up with this:
Dual ducts for better airflow angles at the nozzle
Less agressive angle, less blowing down at the part, more blowing the fresh hot extrusion
Lower to the build plate, quite tight tollerances now at only a few milimeters from the bed
Closer to the hot-end
Did have tree support enabled with some blocking cubes added using cura to prevent them being annoying to get out. You will still need some small tweezers probably to get support out of the ducts. (tree support).
I did not need extra bed adhesion, a small brim could help if you struggle. You still need 2 M3X20 to mount the 5015 fan.
PETG at minimum as it can get hot near the bed
0.2mm layer height
3 walls (did not test 4)
3 roof (did not test 4)
Infill between 25-40 should be good (found gyroid works just fine)
Tree support enabled
Print orientation can be found in the included images.
