1 / 8
Ender 3 v3 SE single 5015 fan split duct right side mount — zdjęcie 1
1 / 8

Ender 3 v3 SE single 5015 fan split duct right side mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Right 5015 blower fan duct for the Ender 3 V3 SE. Closer to the nozzle and bed with an extra exhaust duct

Ocena
0 / 5
Polubienia
3
Pobrania
16
Wydruki
0
Wyświetlenia
131
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Noticed that the origional one from felipejfc did have great airflow but felt like the exhaust could be brought closer to the printbed and nozzle. 

So for my first-ever Fusion 360 design, I came up with this:

  • Dual ducts for better airflow angles at the nozzle

  • Less agressive angle, less blowing down at the part, more blowing the fresh hot extrusion

  • Lower to the build plate, quite tight tollerances now at only a few milimeters from the bed

  • Closer to the hot-end

Did have tree support enabled with some blocking cubes added using cura to prevent them being annoying to get out. You will still need some small tweezers probably to get support out of the ducts. (tree support). 

I did not need extra bed adhesion, a small brim could help if you struggle. You still need 2 M3X20 to mount the 5015 fan. 
 

  • PETG at minimum as it can get hot near the bed

  • 0.2mm layer height

  • 3 walls (did not test 4)

  • 3 roof (did not test 4)

  • Infill between 25-40 should be good (found gyroid works just fine)

  • Tree support enabled

Print orientation can be found in the included images.

Tagi