1 / 12
EV6 Apple MagSafe Charging Mat — image 1
1 / 12

EV6 Apple MagSafe Charging Mat

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Replacement wireless charger for the wireless charging mat in the center console of a 2024 EV6 Wind.

Rating
0 / 5
Likes
1
Downloads
9
Makes
0
Views
57
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial — Share Alike

This MagSafe insert is a complete replacement for the Qi charging mat in my 2024 EV6 Wind. The included charging mat never worked well, and even more so after I upgraded my phone to an iPhone 17 Pro Max, as the large camera bump pushed the phone up and away from the embedded charging coil. This EV6 MagSafe charging mat replaces the rubber mat that came with the car and adds an embedded official Apple MagSafe charger that plugs into the USB-C port on the driver's seat (or passenger's seat if you prefer). I suppose you could also route a longer cable to the USB ports near the floor in front of the console in order to make the cable invisible, but as a driver, you never see the cable when plugged into the driver's seat. 

My design also includes a "shelf" that allows the phone's cameras to sit in a recessed area, which keeps the MagSafe target on the phone and in the mat perfectly aligned. You can now charge your phone at full-power (up to 25W) and since the phone and MagSafe charger remain aligned, the heat generated by wireless charging stays in check. I've tested with several different iPhone models, and it works/aligns with them all.

I created this replacement in the Fall of 2024 and have been using it ever since. It works so well, it's easy to forget it's an "aftermarket" addition. Once you put it in place within the center console and plug it in, it just works. 

Be sure to disable the EV6 built-in wireless charging within the vehicle's settings before installing this MagSafe insert.

The mat is printed with TPU 95A filament so that it is heat-resistant--cars get hot in the summer--and the TPU also prevents scratching on the phone or its case. Prints in 2 pieces, with each piece's top side printed face-down on the buildplate. A standard textured buildplate provides a very nice finish, but I chose to print mine on a hex design textured plate. 

The original model was cut in 2 inside of Bambu Studio with connectors, so the plugs and holes match up perfectly. All voids should be printed with supports. Once supports are removed, a standard Apple MagSafe charger will snap into place, and the cord can be routed through the cable channel to the cord exit at the rear of the mat. 15% infill is fine, as is any infill pattern you prefer. 

There's not quite enough friction with the connectors on their own, so I recommend using some sort of glue to keep the pieces together. Anything will work, and I have even had success with standard white craft glue such as Elmer's.  

The EV6's stock rubber charging mat is held in place by a plug at each corner and can be removed by simply pulling carefully. The charging coil is embedded in the plastic console below the mat, so don't worry about removing or bending the stock mat itself. My design has 4 integrated posts that will fit into the same holes used to secure the original mat. If they do not line up properly, you can cut any of them off and simply use double-sided tape to secure it in place. It's all very forgiving.

I hope this model solves the charging issue for you. It certainly works for me!

Tags