1 / 3
Azoteq TPS43 Trackpad Holder for Corne V4 Pro Micro Edition (right hal — image 1
1 / 3

Azoteq TPS43 Trackpad Holder for Corne V4 Pro Micro Edition (right hal

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

# Azoteq TPS43 Trackpad Holder for Corne V4 Pro Micro Edition (right half) A drop-in trackpad mount for the **Corne V

Rating
0 / 5
Likes
3
Downloads
25
Makes
0
Views
108
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution

# Azoteq TPS43 Trackpad Holder for Corne V4 Pro Micro Edition (right half)

A drop-in trackpad mount for the Corne V4 Pro Micro Edition (Kea Workshop

PCB). It carries an Azoteq TPS43 capacitive trackpad (43 × 40 mm, IQS572)

and bolts onto the right half using the existing RP2040 cover screw holes —

no drilling, no PCB modification. Single printable part.

Project (firmware + sources + STLs):

https://github.com/jos3duardo/corne-tps43-oled

## Features

- Single piece: trackpad frame + factory mounting tab

- Reuses the original RP2040 cover screws — bolt-on, reversible

- Internal retention tabs hold the pad captive against the lid

- Separate 0.6 mm lid that doubles as the touch overlay

- Open bottom: routes discrete wires (SDA, SCL, 3V3, GND) — no FPC needed

- Flat base — prints without supports

## What you need

- 1 × Azoteq TPS43 trackpad module

- 4 × wires (SDA / SCL / 3V3 / GND)

- 2 × M2.5 screws (the original RP2040 cover screws)

## Print settings

- Material: PLA or PETG

- Layer height: 0.2 mm

- Perimeters: 3+ (the lid is thin — it's the touch surface)

- Supports: none · Lid printed flat side up

## Assembly

1. Peel the liner from the pad's factory adhesive (it's on the **sensing face** — intentional).

2. Stick the sensing face to the underside of the lid. The lid is the

overlay you touch, not the bare pad.

3. Drop the pad + lid into the frame; the retention tabs hold it.

4. Solder the four wires and route them through the open bottom.

5. Bolt the piece onto the right half with the original cover screws.

Firmware

Requires QMK/Vial built with the azoteq_iqs5xx driver (stock Kea Workshop

firmware does not include it). I2C on pads D1/D0 (GP2 = SDA, GP3 = SCL),

preset AZOTEQ_IQS5XX_TPS43, ROTATION_270. Full notes in the repo above.

Overlay note

Keep any surface over the sensing face between 0.2 and 1.2 mm and

non-conductive — no metal, metallic paint, or aluminium tape.

## Credits & license

Mounting tab derived from the Corne V4 Pro Micro Edition cover by **Kea

Workshop (klouderone)**, licensed CC BY 4.0 + MIT (© 2023 foostan for the

original Corne). Both permissive; commercial use and modification allowed with

attribution. Shared here under the same terms.

Tags