KRAKEN Motor Fan Mount for 40mm Heatsinks
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A remix of DYocis's excellent remix of RoscoeTheDog's Nema 17 Heatsink and Fan Adapter Mount for 40mm heatsinks.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 3
- Makes
- 0
- Views
- 29
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
This is a remix of DYocis's excellent remix of RoscoeTheDog's Nema 17 Heatsink and Fan Adapter Mount for 40mm heatsinks. I printed mine in LDO Blue ABS using the standard Voron recommended print settings:
Layer height: 0.2mm
Extrusion width: 0.4mm, forced
Infill percentage: 40%. --> recommended for functional parts that are subject to regular use.
Infill type: gyroid or cubic --> cubic is much faster and the same strength as gyroid.
Wall count: 4
Solid top/bottom layers: 5
Supports: None
Brim: if needed for your filament
Print two per motor. I used M3x5x4 heatset inserts to secure the fans. And if you want some fan bling too, these work great: Amazon.com: Alinan 6pcs 4010 24V Color LED Mini Brushless Cooling Fan Transparent
In Klipper I configured the two fans to operate together using multi-pin; and then created a Heater_Fan tied to the Extruder.
[multi_pin motor_fans]
pins: {pin_for_fan#1},{pin_for_fan#2} # just the pins for your MCU without the { braces }
[heater_fan Motor_Fans]
pin = multi_pin:motor_fans
fan_speed: 1.0
heater: extruder
heater_temp: 30.0
I find that if I leave the fans on until the Extruder reaches 30C they drain all of the heat away. Before the fans, using just the heatsinks the motors were averaging 99 - 101C. With the fans, they never get higher than 76C even when printing for hours - and help heat the chamber too!
HAPPY PRINTING and MAY YOUR MOTORS NEVER GET BBQed! 🔥