HDZero Nano V3 Canopy — Babytooth / Toothpick
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
It's a lightweight and stiff canopy for hdzero nano v3 cam, with a cutout for the buzzer and space for elrs antenna
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 29
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
HDZero Nano V3 Canopy — Babytooth / Toothpick
A lightweight canopy for the HDZero Nano V3 VTX, designed around a babytooth-class build. It shrouds the VTX and camera cleanly while keeping mass and its distance from the flight controller (please use some spacers) as low as possible, which is where it earns its keep.
Print settings
I strongly recommend printing in nylon (PA), and adding a few perimeters of PA-CF where you want extra stiffness without dead weight. Straight PA gives you the impact compliance that survives repeated tumbles; the CF layers pull the resonant modes up and out of the range the gyro cares about.
Pairs best with a babytooth frame and a solid set of 1303 motors. In that combination I've measured genuinely low-energy resonance — the canopy doesn't introduce a fixed mechanical mode of its own, so what shows up in the blackbox stays tied to motor RPM rather than sitting as a stationary peak the notches can't reach. That's the whole point of keeping it light and stiff rather than just light.
Camera can be screwer in but I recommend using e6000.