Bug-A-Salt 3.0 Tri-Rail Picatinny Forend
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A remix of @ChubbyEwok_836013 'Bug-A-Salt 3.0 Modded 3-side Picatinny Muzzle'
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 12
- Makes
- 0
- Views
- 121
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Noncommercial
This is a remix of Bug-A-Salt 3.0 Modded 3-side Picatinny Muzzle by @ChubbyEwok_836013
Changes: I changed the overall design and geometry to reflect a more monolithic style, with 'anti-glare' serrations on the top face. I also continued the angle where it meets the Bug-A-Salt at the rear so it appears more integrated. This also makes the bottom-most rail slightly longer, meaning it can accommodate larger attachments. Much like the original, 2x 10mm M3 screws are required to secure the rail onto the end of the Bug-A-Salt.
Suggested Printing Parameters: PETG, 0.2mm layer height @ 25% cubic infill (or more) with organic supports enabled (for ease of removal, supports only required for rail overhangs) oriented with the muzzle exit side (front) face down on the build plate.
Tip: run your table salt through a fine sieve first to remove the finer powdery granules, leaving behind only the larger crystals. This '00 Bucksalt' is much more effective against larger targets and is likely to get the job done with just one hit, and clean up is much easier.
Edit: There is an updated version 2 of this design available, check it out here: