INBXX - LDO Door Panel Hole jig
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A quick and dirty 2-piece jig for drilling holes in the LDO door panels for the INBXX enclosures.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 62
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution
INBXX by Voxel - there was an error in the hole locations on the LDO door panels early on. While this likely will be remediated for future builds, if you're a project OG, you can either use the off-set hinges, or you can print this 2-part jig.
Simply orient the door in place where you need to drill the new holes, clamp it tight and you'll be able to drill a properly located set of holes to use the same hinge on both spots in the door.
Once mounted, the only evidence is one of the originally off-spot holes peeks out below one of the hinges. Do it right and it's below the lower hinge and likely never seen :)
