1 / 6
Heewing T1 / T1-S Ranger tail boom cutting template - Quick release upgrade — image 1
1 / 6

Heewing T1 / T1-S Ranger tail boom cutting template - Quick release upgrade

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

For cutting the Heewing T1 VTOL / T1-S tail to the length of the original T1 PNP.

Rating
0 / 5
Likes
3
Downloads
5
Makes
0
Views
266
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

I prefer the shorter tail boom and more compact size of the original T1. However, to use the new quick-release horizontal and vertical stabilizer, the longer T1-S tail boom is required. The same applies when converting a PNP version to a VTOL.

This template is designed to accurately shorten the tail boom of the Heewing T1 VTOL or T1-S to the same length as the original T1 PNP. More importantly, it ensures that the slot is cut perfectly straight.

It is critical that the slot is centered in the tail boom. If it is not, the horizontal and vertical stabilizers will not be straight. Perform modification at your own risk. 

Instructions: 

  1. Remove the wires inside the tail boom. 

  2. Print the template and slide it into the forward slot of the new T1-S tail boom.

  3. Ensure the template is fully seated and properly aligned before drilling.

  4. Drill the two 2 mm guide holes through the template, then gradually enlarge them to 4 mm.

  5. Drill carefully. Incorrect alignment may permanently damage the tail boom and make it unusable.

  6. Use the cutout on the side of the template to mark the cut line.

  7. Cut the tail boom to length.

  8. Finally, cut the slot by making a straight cut between the outer edges of the two 4 mm holes. This creates a clean, centered slot with a rounded end

  9. VTOL only: For the best airflow beneath the tail motor, mount the motor aft of the wire hole, with the motor wires routed forward through the hole.

Note:  If you are going to upgrade an original T1 to the T1-S quick release stabilizers, please be aware the servo is smaller, and a 4.3g servo is required for the upgrade. 

Support my work: All of my models are available for free. If you'd like to show your appreciation, consider Buying Me A Coffee.

Filament: PLA

Tags