1 / 4
Mercedes Benz W124 Sacco Front Door Wood Trim (Sedan) — image 1
1 / 4

Mercedes Benz W124 Sacco Front Door Wood Trim (Sedan)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Replacement for the Sacco door panel wood trim.

Rating
0 / 5
Likes
1
Downloads
16
Makes
0
Views
195
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial — Share Alike

Hello everyone, 
My door panel wood trim was completely gone on in my W124, therefore I have concluded I should take a shot on creating a replacement. 

The trim is quite long, so therefore it was split into two parts, making it compatible with standard sized print beds.
The interlocking joint was specifically quite difficult to design, since the trim is slim, it has to withstand stretching and contracting caused by cabin temperature changes, and somehow present as much of surface area so the two parts are held together mostly by friction - This should limit the possibility of a "crack" appearing between the two parts. 

I would suggest to print it with ASA - and glue the two pieces together with acetone. 
I couldn't get the ASA print to work, because I don't have an enclosure, and because of the trims length, it warped mid print.
Therefore I printed in PETG, with a mayor downside - the gluing. PETG is hard to glue, and because of the heat cycles that this trim has to go through, causing it contract and expand, cracking the glue, leading to showing the gap between the two parts. ASA and acetone is better, since it glues on molecular level. 

If you print with PETG, the two parts should hold together only by friction as a fallback.

Naturally, do not print with PLA (cabin heat!).

After printing, I sanded it down, applied plastic filler, sanded it until the gap and everything was smooth. 
Then, I applied a vinyl with a heat gun, that looks very similar to the original Sacco trim. 

The vinyl was quite of a pain to get, anything similar looking to the original was only on Aliexpress -  I would add a link here, but the item doesn't exist anymore. I did find the search term you can use though: 
"PVC Self-adhesive Wood Grain Textured Vinyl Auto".

To be able to attach it to the door, you can use flat M3 plastic inserts, or you can make the holes in the trim smaller and just use short wood screws. 

I have it in my car for 2 years now - and everything is OK - except when I slide my finger over it, i can feel the gap between the two parts. If I printed with ASA, glued with acetone, I believe the gap wouldn't have appeared. 

Tags