1 / 12
MTG — Amass Army Dial (0–15, goblin knob) — image 1
1 / 12

MTG — Amass Army Dial (0–15, goblin knob)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A two-part rotating counter for a single growing Army token. Only ONE number is ever visible

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
17
Reviews
0

Updated at source:

Model information

Category
Board Games
License
Creative Commons — Attribution

A two-part rotating counter for a single growing Army token. Dial the army's current size — and only one number is ever visible, through a window in the fixed top cap, so it reads like a tally slate rather than a clock face. Range 0–15, which covers any realistic army.

Thumb rests on the goblin to hold the cap still, fingers turn the exposed scalloped rim. Every number lands with a detent click. Two parts on the plate, no glue, no hardware, no supports.

the window

What you print — one dial and one cap

  • dial.stl — the number wheel: numerals, grip rim, detent tongues, bayonet post

  • dial_2c.stl — alternative to the above, with the numerals as separate inlay plugs. Import → right-click → Split to Parts. This is the intended build if you have AMS: the numbers sit at the bottom of a recessed window where a same-filament engrave disappears into shadow.

  • cap_orc.stl — fixed cap with a chunky arms-folded goblin

  • cap_orc2.stl — fixed cap with a gaunt hooded banner-bearer

  • cap.stl — the bare cap, no figure, for fit-testing the mechanism cheaply

exploded

Assembly — three steps, no force

  1. Line up the release. Turn the cap until its centre slot lines up with the bayonet head on the dial's post. This happens at exactly one place — half a click either side of a number, and nowhere else.

  2. Drop the cap on. It falls into place. No force, no snap.

  3. Turn it to any number. The cap is now captive and cannot lift off until you deliberately hunt for that same half-click position again.

To take it apart, reverse step 1.

both figures

Print settings — the figure needs cooling

The goblin is ~23 mm tall but only ~2 cm³, so its average cross-section is about 87 mm² — roughly a 10 mm circle. At 0.2 mm layers that is a couple of seconds per layer, and each new layer lands on plastic that has not frozen yet. At default settings the figure comes out glossy and slumped, ears and face melted away, and the taller cap_orc2 suffers worse than cap_orc because heat accumulates going up.

Set minimum layer time to 15–20 s ("slow down for better layer cooling"), part cooling fan to 100 %, and drop the nozzle ~10 °C. Printing both caps in one job helps too. The dial and the mechanism print fine at defaults — this applies only to the figure.

printed

Parametric

The mechanism is original OpenSCAD and the .scad is included — position count, dial diameter, detent strength and window size are all top-level variables. Note that numbers read tangentially, so raising the position count shrinks the pitch a two-digit label has to fit in.

Tags