1 / 4
ECAS04 Y-Splitter for Sovol SH02 Filament Dryer — image 1
1 / 4

ECAS04 Y-Splitter for Sovol SH02 Filament Dryer

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

An ECAS04 remix of Giles Santen's PC4-M10 version.

Rating
0 / 5
Likes
2
Downloads
10
Makes
0
Views
110
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial — Share Alike

Y-Splitter for Sovol SH02 with ECAS04 Fittings

This is a remix of the PC4-M10 version.

I measured the fittings precisely with a caliper and sized the holes accordingly. You should be able to insert the fittings easily and get a tight fit.

Don't forget to remove the rubber rings from the fittings first!

Print Instructions

Ideally, y-splitters should be printed horizontally so that the layer lines are parallel to the filament and therefore not cause any friction.

Unfortunately, most designs can only be printed vertically, with layer lines perpendicular to the filament, maximizing the friction!

A middle ground is to print at as low an angle as possible, without needing supports inside the splitter.

I attached my .3mf file, and I strongly recommend printing it at the same 45-degree angle. This avoids internal supports and reduces friction compared to a vertical print. See the second picture for how it looks.

Please leave a comment if you have feedback or any questions :)

Tags