Quena — 3D Printed Andean Notch Flute in G
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 3D-printed quena (end-blown Andean notch flute) in G -- the traditional home key for this instrument.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 14
- Makes
- 0
- Views
- 63
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
# G Quena -- 3D Printed, 20mm Bore
A 3D-printed quena (end-blown Andean notch flute) in G -- the
traditional home key for this instrument, so nothing exotic about the
pitch choice. Built as a direct notch-embouchure adaptation of an
existing, already-tuned 20mm-bore Alto G whistle, rather than designed
from scratch: https://www.printables.com/model/1791116-g-alto-tinwhistle-20mm-bore-printed-fipple-mouthpi
## Three pieces
- Head -- the notch (embouchure) end. Rounded U-shaped notch, not a
sharp V, for a more forgiving blowing angle while learning the
instrument and a closer match to the worn rim shape on traditional
cane quenas.
- Middle -- 6 front finger holes plus 1 back thumb hole (7 total,
the traditional layout).
- Foot -- unmodified from the source whistle's own foot piece. No
changes needed; the bore and joint already matched.
## Playing status
Confirmed against a tuner: **the full first octave is correctly in
tune.** That's the core validation for the whole design -- the hole
positions were carried over from an already-tuned fipple whistle by
translating them into distances from the acoustic origin rather than
guessed at fresh, and the tuner check confirms that transfer actually
worked.
The second octave (reached by overblowing, standard for a quena --
there's no register key) gets unstable partway through in testing so
far. Given the first octave is confirmed correct on the same air
column, this points at embouchure control rather than a bore or hole
problem -- the overblown register on any notch flute takes real
practice to control consistently, more so than on a ducted/fipple
instrument, and this is a first attempt on a genuinely difficult
embouchure type. Not treating this as a design defect unless further
playing suggests otherwise.
One thing worth noting for anyone else building this: the thumb hole
turned out to help reach the higher octave cleanly, acting something
like a register vent rather than only extending the low end of the
scale, which wasn't specifically designed for -- a nice bit of
behavior that emerged from testing rather than being planned.
## Known limitations, honestly
- The notch's acoustic end-correction was estimated by analogy to the
source whistle's fipple, not measured directly -- close enough that
the first octave came out correctly tuned, but not a guaranteed
match for a different bore or key.
- Hole diameters were carried over directly from the fipple whistle as
a first-pass estimate. They may still want individual adjustment
(enlarging, never shrinking) as more playing reveals any notes
sitting slightly off from the rest.
- This is one player's results on one build. Limitations noted above
are about the instrument's design process; the second-octave
instability specifically looks like a player-experience issue, not
a design one.
License
CC BY-NC-SA — free to use, remix, and share for non-commercial purposes with attribution.
Credits
Design by Untemperedsteel. OpenSCAD development assisted by Claude (Anthropic).