Bunn Airpot Lever
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A thicker, more substantial version.
- Rating
- 5 / 5
- Likes
- 4
- Downloads
- 103
- Makes
- 0
- Views
- 492
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
A thicker, more substantial version.
A lever inside the housing of a common commercial Bunn Airpot can get weak and/or break. When the pump pot is full of coffee and eager folks press hard on the outside lever it stresses this part because there is not much air in the container. Since liquid doesn't compress, the higher than usual pressure weakens this lever.
This design is beefier than the part is originally. This part has been tested in commercial environment. It will also eventually break, but holds up as well as the original part.
Print instructions
Category: Parts Print Settings
Printer Brand: Prusa
Printer: i3 MK2S
Rafts: Doesn't Matter
Supports: Yes
Resolution: 2mm
Infill: 100%
Notes:
I used PLA and it was strong. Other materials could make it stronger.