Wasp Trap for Standard Mason Jar
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a remix of Václav Bláha's model reduced slightly and fitted into a screw top lid for a standard mason jar.
- Rating
- 5 / 5
- Likes
- 6
- Downloads
- 39
- Makes
- 1
- Views
- 152
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Summer
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of Václav Bláha's model reduced slightly and fitted into a screw top lid for a mason jar. The original was slightly too large to sit on top of the mason jars I have (for jams, pickles, etc.) Once shrunk, I remixed it with a regular mason jar lid (https://www.tinkercad.com/things/l0BIdgHI8Ee-regular-mouth-mason-jar-lid) so that it could be screwed on ensuring it did not pop off.
I've also included a 2nd version with only 5 openings and vent slots. The bottom of the cone in each trap is 7mm.
If you run into problems with bees squeezing through the openings because your bait is just too delicious to resist :-), there is a version with a 5.5mm opening at the bottom of the cone. It should still allow wasps to enter and prevent any bees from squeezing through.