Wasp Trap for Standard Mason Jar
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of Václav Bláha's model reduced slightly and fitted into a screw top lid for a standard mason jar.
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 39
- Wydruki
- 1
- Wyświetlenia
- 152
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Summer
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of Václav Bláha's model reduced slightly and fitted into a screw top lid for a mason jar. The original was slightly too large to sit on top of the mason jars I have (for jams, pickles, etc.) Once shrunk, I remixed it with a regular mason jar lid (https://www.tinkercad.com/things/l0BIdgHI8Ee-regular-mouth-mason-jar-lid) so that it could be screwed on ensuring it did not pop off.
I've also included a 2nd version with only 5 openings and vent slots. The bottom of the cone in each trap is 7mm.
If you run into problems with bees squeezing through the openings because your bait is just too delicious to resist :-), there is a version with a 5.5mm opening at the bottom of the cone. It should still allow wasps to enter and prevent any bees from squeezing through.