Flashforge Chamber Heater
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Chamber heater
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 15
- Makes
- 0
- Views
- 181
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I am not responsible if your heater burns out.
I modeled it quickly; there are things that would be better to change. I’ll change the mounts for inserting brass nuts later. I printed it from ASA, but I haven’t tested it in operation yet. There will also be a small separate control and power unit. A small hole is cut in the plastic housing of the heater from below for the thermal fuse; the grille is removed, leaving only the mounts that hold the heater. To prevent the heater from moving around in the housing, I wrapped it in a circle with Kapton tape.
2 temperature sensors DS18B20 , PTC heater 92x31x25 Any one that’s more convenient; I have 220V, 150W. Fan 5015 (dual bearind) 12v