1 / 4
Ender 3 Triple 4010 Radial Fan Mainboard Cover — image 1
1 / 4

Ender 3 Triple 4010 Radial Fan Mainboard Cover

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A top cover for the Ender 3 mainboard enclosure. Uses three 4010 blowers to direct air towards the stepper drivers.

Rating
0 / 5
Likes
2
Downloads
7
Makes
0
Views
61
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

I upgraded my stepper motors, raised the current accordingly, and noticed that the heatsink on my BTT SKR Mini E3 V3 was running too hot to even touch. Having bought a 2-pack of 4010 blowers a while ago, and having scavenged a third from the stock ender 3 hot-end, this is was my solution.

UPDATE:  Since producing the renders shown I've slightly moved the fans to the left and adjusted the angle of the blower outlets. These changes were subtle enough I don't think it warrants redoing those renders, but let it be known: changes have been made.

Printing:

I enabled ironing for all top surfaces on both prints

Assembly:

The factory cable routing with side-mounted strain relief on these fans interferes with their tight spacing. You'll have to re-route the wires to exit from the back of the fan, though this eliminates the built-in strain relief. Since strain relief is important to protect the solder joints, I used some hot glue to tack the wires in place.

The inlet duct is designed to accept Ruthex M2 heat-set inserts. All 12 machine screws (M2, 12 to 16mm) pass up through the fans, the top cover, and fasten to the inlet duct.

I designed and rendered the model around BigTreeTech's SKR Mini E3 V3 CAD model and SonOvaSailor's Ender 3 CAD model

Tags