Replica of Irish water access lid
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A replica of a water access lid that I saw in Galway, Ireland. I reconstructed the 3D shape from a photo.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 12
- Makes
- 0
- Views
- 106
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- 2D Plates & Logos
- License
- Creative Commons — Attribution — Share Alike
I saw this cover on the street while in Galway and was impressed by the artistry of such a functional object. It is less than a foot across and probably intended to cover a water valve or meter.
I saw a few others like it. Most of the newer ones simply say "uisce" (water) in plain letters without any design.
The model is based on a height map derived from the photo. I had to guess how much the lettering was raised, but it looks reasonable. The two holes (round and keyhole shaped) were in the original photo so I kept them for accuracy.
The included model prints at 100cm diameter. I have not tried it yet, but have printed one scaled down to 6cm and that prints well enough to see the design.
The 6cm model is too small to get all the detail. Here's a 3D render (or you can go to the model viewer). It should look better at 10cm or scaled up from there. I intentionally flattened some of the texture of the original metal, since it would be less than the 3D print and increase the size of the STL file.
I added two other models with bases, increasing the height to 8mm and sealing the holes in the bottom. It is intended as a coaster. I have tested if the raised arrow is a problem for using as a coaster. In the 9mm model, I reduced it slightly. I think it is raise on the original, but I can't be certain with just a single photo.
