1 / 1
Renault Vel Satis - Parcel Shelf Hanger / Hanger Pin Clip (Wieszak Półki Bagażnika) — image 1

Renault Vel Satis - Parcel Shelf Hanger / Hanger Pin Clip (Wieszak Półki Bagażnika)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

PL: Wieszak półki bagażnika Renault Vel Satis. Druk PETG 100%, śruba M3x20. EN: Renault Vel Satis parcel shelf hanger.

Rating
0 / 5
Likes
1
Downloads
8
Makes
0
Views
41
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial — Share Alike

PL

Element zastępczy (wieszak / kołek) służący do zawieszenia półki bagażnika w samochodzie Renault Vel Satis. Oryginalne uchwyty po latach często wycierają się, pękają lub gubią, co powoduje opadanie półki przy otwieraniu klapy bagażnika.

Ten model został zaprojektowany od podstaw, aby idealnie pasować w fabryczne miejsce montażowe i przywrócić pełną funkcjonalność podnoszenia półki.

Wskazówki dotyczące druku / Print Settings:

  • Materiał: PETG (zalecany ze względu na odporność na temperatury panujące w pojeździe oraz elastyczność).

  • Wypełnienie (Infill): 100% (dla maksymalnej wytrzymałości mechanicznej elementu).

  • Wysokość warstwy (Layer height): 0.08 mm (zapewnia doskonałą precyzję, gładkość i mocne spójności warstw).

  • Orientacja i podpory: Wydruk w orientacji poziomej z zastosowaniem podpór (supports).

Montaż:

  1. Element montowany jest na wcisk w fabryczne miejsce.

  2. Dla pełnego zabezpieczenia i stabilności należy dokręcić go śrubą M3 x 20 mm.

EN

A replacement hanger pin / clip for the rear parcel shelf in the Renault Vel Satis. Over time, the original plastic hangers often wear out, snap, or go missing, preventing the parcel shelf from lifting properly when the tailgate is opened.

This model was designed from scratch to fit the original mounting points perfectly and restore the full functionality of the trunk shelf.

Print Settings:

  • Material: PETG (strongly recommended for heat resistance inside the vehicle and good durability).

  • Infill: 100% (for maximum mechanical strength).

  • Layer Height: 0.08 mm (for smooth finish and fine detail accuracy).

  • Orientation & Supports: Print horizontally with supports enabled.

Assembly / Installation:

  1. The part is installed as a press-fit (push fit) into the factory location.

  2. Secure it permanently using an M3 x 20 mm screw.

Tags