1 / 5
Higher Clearance Ultra Low Profile Parts for Belt Driven Ender 3 — image 1
1 / 5

Higher Clearance Ultra Low Profile Parts for Belt Driven Ender 3

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A rework of the "Ultra Low Profile" parts from KevinAKASam's Belt Driven Ender 3 mod to reclaim the full Z build height.

Rating
0 / 5
Likes
2
Downloads
7
Makes
0
Views
114
Reviews
0

Updated at source:

Model information

License
GNU General Public License v3.0

The original ultra-low-profile top end from KevinAKASam's Belt Driven Ender 3 mod comes at the cost of build volume, as the Z-plates will collide with the transmission before reaching the stock 250mm build height of the Ender 3.

This remix seeks to rectify that, as well as implement a couple of my own design preferences.

Instead of mounting to the 2020 extrusion with M5 pan-head screws, this version uses a combination of countersunk M4 and M5 screws.

The new transmission is perfectly compatible with the original pulley supports (and therefore belt length,) so if you're modifying an existing ultra-low-profile setup, you don't have to replace what you already have.

If you're running a dual-motor setup, simply mirror the transmission in your slicer to accommodate the left side motor.

Fasteners needed to mount these parts to your frame are as follows:

Part

Note

Quantity

M5x8 Countersunk

for all front t-slot mounts and rear on transmission

7

M4x8 Countersunk

for the remaining rear t-slot mounts

3

M5 T-slot nut

7

M4 T-slot nut

3

"Oversize?"

Since the bearings are an interference fit, the bores into which they're pressed are a sensitive dimension. I found that depending on print surface quality, the original 0.2mm bore oversize can range between perfect and far too large. To accommodate this, I've produced a few variants with tighter tolerances on the bearing bores. The same is also applied to the part which slides over the 2020 extrusion.

If after printing everything you find that you have a loose-fitting bearing (I found that the main transmission housing was looser than the pulley supports on my print) you can easily shim the bearings with foil tape, available at any hardware store with an HVAC section.

Tags