Bee-Link EQ14 wall mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple wall mount for the Bee-Link EQ14 NUC
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 7
- Makes
- 0
- Views
- 24
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a wall mount for the Bee-Link EQ14 NUC.
It does not require you to remove the feet, so if you want to remove it and use it elsewhere again that's fine.
Required hardware:
Screws suitable to wall mount it. It's not that picky, whatever fits :)
Printing instructions:
Strength at your discretion. I printed with the following settings:
3 perimeters
15% infill
Gyroid
PETG (for heat resistance), though PLA might very well be fine too. There are no vents by the filament, and these NUCs run pretty cool.
You can print it in either orientation. You'll need supports regardless. I chose to print the front down for the patterns sake.