Bee-Link EQ14 wall mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple wall mount for the Bee-Link EQ14 NUC
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 24
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a wall mount for the Bee-Link EQ14 NUC.
It does not require you to remove the feet, so if you want to remove it and use it elsewhere again that's fine.
Required hardware:
Screws suitable to wall mount it. It's not that picky, whatever fits :)
Printing instructions:
Strength at your discretion. I printed with the following settings:
3 perimeters
15% infill
Gyroid
PETG (for heat resistance), though PLA might very well be fine too. There are no vents by the filament, and these NUCs run pretty cool.
You can print it in either orientation. You'll need supports regardless. I chose to print the front down for the patterns sake.