1 / 4
Boya BY-V (BY-V20, BY-V2, BY-V10, BY-V1) Rugged Case — image 1
1 / 4

Boya BY-V (BY-V20, BY-V2, BY-V10, BY-V1) Rugged Case

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A hinged case for Boya BY-V series microphones

Rating
0 / 5
Likes
2
Downloads
12
Makes
0
Views
43
Reviews
0

Updated at source:

Model information

Category
Organizers
License
Creative Commons — Attribution — Noncommercial — Share Alike

Boya BY-V Series Microphones Rugged Case

Compatibility

The case is made specifically for and tested with BY-V20 microphones, but it should be good with:

  • BY-V1

  • BY-V10

  • BY-V2

  • BY-V20

The microphones themselves are similar, the only difference between models with and without 0 is the receiver connector (Lightning or USB Type-C) and one or two mics between V1 and V2 variants.

If you have a set with only one mic (V1 or V10) this case will still work fine, making it smaller while still trying to retain all the rugged edges and latches hardly makes sense in my opinion. You just can use a spare cavity for something else, use your imagination! :)

Printing

Please note that the inlay and the seal should be printed with TPU or other soft/flexible filament due to small rounded ridges inside the cavities of the inlay designed to be quite snug to hold the microphones in place. The example was printed and tested with TPU only, printing with "normal" rigid filaments might work but is discouraged! Do it at your own risk. And please inform me if it works in case you try it.

The latch is best printed standing on its side.

Screws

Like the original (and the original's original) case, this one requires 3 (three) M3x30 screws that you must source yourself, obviously. You can use whatever you like, any type of head (I think rounded heads look the best) or "set screws" with no visible heads at all. You just can't assemble it with no screws, mind that!

Tags