Fujifilm X100VI thumb grip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Specific Fujifilm X100VI thumb grip. Fits layout, high risk of breakage at bottleneck, recommends spares. Use caution wi
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 14
- Makes
- 0
- Views
- 82
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 3D-printable hot shoe thumb grip designed specifically for the Fujifilm X100VI. The geometry provides an ergonomic thumb rest for increased stability during one-handed use, without obstructing access to the X100VI's layout.
Layout Compatibility
This item curves precisely around the Fujifilm X100VI’s specific Exposure Compensation dial and rear command joystick. All top-plate controls remain fully accessible. This clearance is unique to the X100VI and might not align with other X100 series or Fujifilm bodies.
Technical Specifications & Material Warnings
This model prioritizes a slim ergonomic profile, which creates a specific engineering weakness at the thinnest section (the bottleneck).
Engineering Weakness: The bottleneck section is highly prone to breakage under moderate stress.
Material Recommendation: Print ONLY in strong, durable materials with optimized layer adhesion, such as Nylon (PA), ASA, or ABS. Standard PLA and PETG are too brittle and will fail quickly. I usually use PLA and PETG, which will likely break at the thinnest section; proceed with caution if choosing these materials.
Usage Advice: Given the inherent weakness, always print and carry spares.