Fujifilm X100VI thumb grip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Specific Fujifilm X100VI thumb grip. Fits layout, high risk of breakage at bottleneck, recommends spares. Use caution wi
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 76
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 3D-printable hot shoe thumb grip designed specifically for the Fujifilm X100VI. The geometry provides an ergonomic thumb rest for increased stability during one-handed use, without obstructing access to the X100VI's layout.
Layout Compatibility
This item curves precisely around the Fujifilm X100VI’s specific Exposure Compensation dial and rear command joystick. All top-plate controls remain fully accessible. This clearance is unique to the X100VI and might not align with other X100 series or Fujifilm bodies.
Technical Specifications & Material Warnings
This model prioritizes a slim ergonomic profile, which creates a specific engineering weakness at the thinnest section (the bottleneck).
Engineering Weakness: The bottleneck section is highly prone to breakage under moderate stress.
Material Recommendation: Print ONLY in strong, durable materials with optimized layer adhesion, such as Nylon (PA), ASA, or ABS. Standard PLA and PETG are too brittle and will fail quickly. I usually use PLA and PETG, which will likely break at the thinnest section; proceed with caution if choosing these materials.
Usage Advice: Given the inherent weakness, always print and carry spares.