Body Panels and Battery Box for the INJORA 1/10 Nylon Rock Buggy Roll Cage
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Body Panels and Battery Box for the INJORA 1/10 Nylon Rock Buggy Roll Cage. The hood will need to be bent to fit.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 4
- Makes
- 0
- Views
- 119
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a full set of body panels for the 1/10th scale INJORA Nylon Rock Buggy as well as a custom battery box. I run a 2200 3S battery, and it fits the battery box with a little room to spare. The interior and rear panels snap into place and don't need any screws or glue. You only need to print one rear panel, one is a full panel and the other is half. The roof, hood and door panels use the original screws. The hood is printed flat and will need to be heated up with a hair dryer or heat gun to put the bend in it. This can be a little difficult if you have never tried it before. I mounted the hood to the chassis and then slowly heated the area that needed to bend. Once the hood started to sag on its own, I used a flat piece of wood to bend the hood down and held it there until it cooled. I printed everything on my Flashforge Adventurer 5M with a .4 nozzle and a .2-layer height and 3 wall loops. I used 100% infill for durability. PLA, especially in black will likely try to warp in direct sunlight so I recommend at least using PETG.