1 / 12
Body Panels and Battery Box for the INJORA 1/10 Nylon Rock Buggy Roll Cage — zdjęcie 1
1 / 12

Body Panels and Battery Box for the INJORA 1/10 Nylon Rock Buggy Roll Cage

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Body Panels and Battery Box for the INJORA 1/10 Nylon Rock Buggy Roll Cage. The hood will need to be bent to fit.

Ocena
0 / 5
Polubienia
2
Pobrania
4
Wydruki
0
Wyświetlenia
119
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a full set of body panels for the 1/10th scale INJORA Nylon Rock Buggy as well as a custom battery box. I run a 2200 3S battery, and it fits the battery box with a little room to spare. The interior and rear panels snap into place and don't need any screws or glue. You only need to print one rear panel, one is a full panel and the other is half. The roof, hood and door panels use the original screws. The hood is printed flat and will need to be heated up with a hair dryer or heat gun to put the bend in it. This can be a little difficult if you have never tried it before. I mounted the hood to the chassis and then slowly heated the area that needed to bend. Once the hood started to sag on its own, I used a flat piece of wood to bend the hood down and held it there until it cooled. I printed everything on my Flashforge Adventurer 5M with a .4 nozzle and a .2-layer height and 3 wall loops. I used 100% infill for durability. PLA, especially in black will likely try to warp in direct sunlight so I recommend at least using PETG.

Tagi