Elegoo Centauri Carbon error 101 & 103 fix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Reinforcement bracket to fix the USB connection on top of the extruder.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 17
- Makes
- 0
- Views
- 187
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
After about 500 printing hours with my ECC1, I encountered problems with Error 103 Hotend heating error and later Error 101 communication error printhead.
After some search on the Internet and removing the cable, i found out that the rubber mold on the connector deforms after a while and pulls out the connector out of the USB slot slighty. You can fix this by printing this small model and cut the 2 sides from the mold around the connector (this are the 2 wings where the screws go through) and place the USB connector back in, and place the small bracket over the connector.