Modular Lightsaber Pegboard Mount

An extensible system to mount lightsabers to a standard Imperial unit pegboard (theoretically, it could also work on a metric board, but I have no way of testing it, so your mileage may vary). It uses a standard baseplate with modular hooks that can be edited to be compatible with any saber with a diameter of less than 26.5mm. The mount then slides over 2 3D-printed hooks that dovetail into the baseplate, holding it in place. The remote blade hooks work the same way. The hooks are attached to the baseplate with M3x8 screws, with up to two screws per hook (I've found that one screw in the top hole is typically enough though). Included in the files are hooks for the sabers that I personally own (with some hooks for standard 33mm sabers), and blank STEP files to make your own. There are also some vertical designs for the crossguard that I did not end up using due to space constraints, but should work just fine otherwise. These require an additional screw to assemble the 2-part stabilization hooks.

The _l and _r suffixes are nonsensical and the hooks can be reversed to reverse the saber direction, with the exception of the Luke saber, which requires one hook to be mirrored in the slicer for it to be reversed.