LRS-150-24 PSU Cover for AxxSolder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
LRS-150 cover with separate socket, switch and three-pinned MR60 output connector.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 30
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed a compact cover for my LRS-150-24 that would expose the protective earth (PE) pin in addition to the positive and negative terminals so that I could use it with my AxxSolder soldering station. I also wanted to reuse some of the existing C14 sockets and switches I had laying around vs the larger integrated socket-switch of the original design by Fuzebox.
For the connector instead of the XT60 of the original design I decided to use the three-pinned MR60 version. They're cheap and quite beefy not unlike XT60, but the only downside is that I could not find a panel-mount version of it, so had to design for a glued+friction-fit option. This makes the connector pretty much single-use, but nothing to cry about since they do cost about $1.
MR60 connectors can be bought from TME, Amazon or AliExpress (not affliated).
I used a trapezoidal C14 socket and a toggle switch from a broken ATX PSU, so no model number, measure and modify the OpenSCAD design appropriately, if needed.
To connect to AxxSolder a length of flexible SiHF 3x1.5mm2 cable was used + the corresponding connectors.
Additionally two M3x10 flathead screws + rectangular nuts were used to keep the C14 socket in place.
To make the PSU stand vertically there's an excellent design by Tzach.
